Engineering Tool - Helix Linear Technologies

Helix Engineering Tools

Below is a listing of the engineering tools available on our website to assist you with your particular application. These tools consist of various calculators, charts and application data froms that you can fill out and submit to our expert linear motion solution engineers for their input.

Please select the appropriate tool from the list below:

Engineering Calculators

HORSEPOWER – The amount of power needed to drive a load.

The calculator takes the input shaft speed and the torque required for a given load and derives the amount of horsepower or kilowatts expended. It can also back-calculate either the torque or the speed resulting from a particular power requirement.

HorsePower
Kilowatt


ACME NUT PV VALUE – An acme/trapezoid nut material limitation based on speed and pressure.

Unit pressure on the nut (P) and surface velocity at the nut/screw interface (V) limit the use of a particular material in an application because of the resulting heat build up and accelerated wear. All Helix Linear Technologies nut materials have a limiting PV value.

This calculator compares the actual operating load and speed against the PV rating of the chosen material. Calculations for both Nook BronzAC and PlastAC materials in inch and metric units are available.

Inch Plastic PV
Metric Plastic PV


CRITICAL SPEED – The input speed which excites the resonant frequency of a system.

The calculator uses the diameter, unsupported length and end fixity to determine the approximate rotational speed at which resonance will occur. It can also back-calculate to determine the diameter or length based on a specific screw rpm.

See the Acme Critical Speed Chart to verify the correct screw for the application.

Inch Critical Speed
Metric Critical Speed


COLUMN STRENGTH – The compression load at which a column will fail due to bending or buckling.

The calculator uses the diameter, unsupported length and end fixity to determine the approximate minimum diameter required to support a given load. It can also back-calculate to determine the diameter or length based on a specific load.

See the Acme Column Strength Chart to verify the correct screw for the application.

Inch Column Strength
Metric Column Strength


UNIT CONVERSION – Conversion between Inch and Metric units.

Unit Converter


Application Data Forms

Use the following form to help clarify the requirements of your application. Once you have completed the appropriate form, you can submit it (Online Form Version), email or fax it (PDF Version) to one of our experts for their assistance in selecting the ideal linear motion solution for your application.

ACME & LEAD SCREW APPLICATION DATA FORM (Online Form)

ACME & LEAD SCREW APPLICATION DATA FORM (PDF Version)

LINEAR SYSTEMS APPLICATION DATA FORM (PDF Version)

Quick Reference Guide

QUICK REFERENCE GUIDE TO NUT MATERIALS